Hello,
I am working on a used Kuraki KBT-13E-A that we are in the process of setting back up in our shop. And I have run into a issue with Fixture offset writing from the program. Normally we use G10 L2 P# to do so, but I am getting an "Illegal G-Code" Error as soon as I try to read a G10.
Does anyone know of a parameter setting that might effect the use of G10? I know I can use variables to set a fixture offset, but I would prefer to use G10 L2 as we do in our other 2 Kurakis and the rest of the shop. Any ideas are very appreciated.