Started a new job today and the bossman showed me a brand new OSG (cobalt I believe) drill that hadn't made it through one part. It was leaving a poor finish and actually wallered out the top of the whole so badly that it scrapped the part. I looked on OSG's website and found little help. I figure the speeds and feeds should be round 60 SFM and .006 to .010 IPR which is about what they were running it at. It is not a Through Tool coolant drill so Im assuming pecking is needed. OSG said it could just be a bad drill but I still wonder. Any advice for drilling and tapping 316 stainless would be appreciated.