Stepper Motor Speed Pulse Controller and Driver Board 2 Control Modes from USA | eBay
I cant seem to figure out what purpose it serves.
Stepper Motor Speed Pulse Controller and Driver Board 2 Control Modes from USA | eBay
I cant seem to figure out what purpose it serves.
It appears to be a stepper drive controller and movement can be controlled either by simple PB pulse or a 5v step dir input.
At least that's what I see (two control modes!).
You should be able to use a PWG input to manually control it?
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Ah! I think this is what I was looking for with regards to having a "stepper powerfeed" type setup in my earlier post. Do you think it would work?
It appears to me that would work.
Either a 100p/rev encoder or a S.H. Pulse Wheel should offer manual operation.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.