586,100 active members*
2,810 visitors online*
Register for free
Login

Thread: Mach 3 Turn

Results 1 to 3 of 3
  1. 05-26-2011, 07:16 PM #1
    Grandad
    Grandad is offline Registered
    Join Date
    Feb 2006
    Posts
    50

    Mach 3 Turn

    I need to change the input on the manual screen from radius mode to diameter mode, can any body help.....
    Reply With Quote Reply With Quote
  2. 05-26-2011, 09:10 PM #2
    Grandad
    Grandad is offline Registered
    Join Date
    Feb 2006
    Posts
    50
    OK no problem I found it
    Reply With Quote Reply With Quote
  3. 10-12-2012, 04:56 PM #3
    1armsbandit
    1armsbandit is offline Registered
    Join Date
    Dec 2009
    Posts
    36
    It's on the ports and pin config page,far right side. There you can select diameter or radius.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. CAM Software for Mach 3 Turn
    By fidia in forum Mach Software (ArtSoft software)
    Replies: 4
    Last Post: 03-12-2011, 01:47 PM
  2. bobcad v24 and mach-turn
    By ludovanginderen in forum BobCad-Cam
    Replies: 1
    Last Post: 01-29-2011, 01:42 PM
  3. cant get mach turn to run
    By panaceabea in forum Mach Software (ArtSoft software)
    Replies: 0
    Last Post: 12-10-2007, 02:56 PM
  4. How to program in Mach turn ?
    By JDsto in forum Mach Software (ArtSoft software)
    Replies: 4
    Last Post: 11-29-2007, 08:39 PM
  5. Confused: Mach Turn, Mach Mill, Mach 2/3 ?
    By CanSir in forum Mach Software (ArtSoft software)
    Replies: 5
    Last Post: 02-16-2007, 11:41 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules