586,356 active members*
2,798 visitors online*
Register for free
Login

Thread: HURCO MD-1 ATC

Results 1 to 2 of 2
  1. 06-01-2011, 07:48 PM #1
    MTIjake
    MTIjake is offline Registered
    Join Date
    Feb 2011
    Posts
    0

    HURCO MD-1 ATC

    Anyone know if there is a way to stop the table from moving to the aixs limits before doing a tool change with the ATC. On the parts I'm running it is not required and wastes a lot of time.

    Thanks
    Reply With Quote Reply With Quote
  2. 06-01-2011, 08:15 PM #2
    bloke
    bloke is offline Member
    Join Date
    Jun 2008
    Posts
    1104
    Program parameters in the input page should have a field called toolchange position . Set it to no.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Anyone Have a Hurco Tape Emulator/Hurco Tapes?
    By KyleH2 in forum HURCO
    Replies: 2
    Last Post: 01-06-2010, 12:26 AM
  2. Hurco and Bob CAD
    By RDS in W PA in forum Community Club House
    Replies: 2
    Last Post: 03-31-2009, 04:21 AM
  3. Hurco, KM-1
    By dafowfidy in forum Bridgeport / Hardinge Mills
    Replies: 2
    Last Post: 11-08-2008, 12:18 AM
  4. Hurco KM-1
    By dafowfidy in forum HURCO
    Replies: 4
    Last Post: 03-05-2007, 07:54 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules