586,082 active members*
3,534 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Knee Vertical Mills > Need help, Where to start on converting a Supermax mill to Mach

Thread: Need help, Where to start on converting a Supermax mill to Mach

Results 1 to 2 of 2
  1. 06-05-2011, 04:12 AM #1
    sandtrx
    sandtrx is offline Registered
    Join Date
    Jun 2011
    Posts
    0

    Need help, Where to start on converting a Supermax mill to Mach

    Hi everyone,

    I just aquired a Supermax mill with an Anilam Crusader 2 controller on it. It does have glass scales, along with SEM servo motors.

    I want to convert it to Mach 3, but am unsure of the total of everything that i need to do and what parts that i need. I know the controller comes off, along with the glass scales, but what about the electronics in the box on the side of the mill. (I know i sound extremely dumb and shouldn't be messing with this, but please humor me).

    Thank you for the time that it's going to take to educate an idiot.

    Matt
    Reply With Quote Reply With Quote
  2. 06-10-2011, 03:47 PM #2
    Jackal66
    Jackal66 is offline Registered
    Join Date
    Sep 2006
    Posts
    300
    Matt,

    These guys are a lot of help.

    Try posting in the Mach section on here.

    Also go to the Mach3 forum.

    Machsupport Forum - Index

    JAckal
    Everything is bio-degradable, if you run over it enough times with the lawnmower.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Converting a Brothers TC-225 to use Mach 3
    By dannyboysd89 in forum Mach Software (ArtSoft software)
    Replies: 1
    Last Post: 10-06-2016, 03:20 PM
  2. Converting an old Routermaster RM25 to Mach system.
    By SOSx in forum Commercial CNC Wood Routers
    Replies: 9
    Last Post: 04-24-2011, 03:32 AM
  3. Adding cycle start to mach 3 mill
    By Dr Doofensmirtz in forum Mach Mill
    Replies: 4
    Last Post: 03-06-2011, 02:59 AM
  4. Converting Anilam 1100m to mach 3
    By BillsBoatRepair in forum Mach Mill
    Replies: 1
    Last Post: 07-23-2009, 03:36 AM
  5. Converting a Crusader M (Anilam) with steppers to Mach 3 - what does it take?
    By radioactive in forum Uncategorised MetalWorking Machines
    Replies: 0
    Last Post: 01-26-2009, 06:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules