Sounds like you need to set the origin in CamBam to the center of your pocket.
Also, is Mach3 set up correctly, so that when you tell it to move 1", it actually moves 1"? If so, then the problem is most likely CamBam. Can you post the code?
Sounds like you need to set the origin in CamBam to the center of your pocket.
Also, is Mach3 set up correctly, so that when you tell it to move 1", it actually moves 1"? If so, then the problem is most likely CamBam. Can you post the code?
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)