Hi, my machine is still not powered up as I'm waiting on a contractor to open up a wall (long story).

How can I tell if it takes BT40 or CAT40?

Do they use a standard pull stud? I compared someone that was advertising "Fadal pull studs" with the studs sold at Maritool and there were two candidates but I could not confirm because some dimensions were for different features.... plus both were for BT40

http://www.maritool.com/p570/Pull-St...duct_info.html
http://www.maritool.com/p806/Pull-St...duct_info.html

BTW, I do have about twenty BT40 Lyndex holders (ER16, TG100, and a Floating Tap) which I would like to use. Though it would not be the end of the world if I did not.

Thanks!