Hooking up my spindle and after making my motor cable determined that the ground pin (pin 4) is not connected.
I am disappointed it is not connected. To my mind is a huge safety issue!
My cable is finished on motor end and don't really want to re do it. Managed to get everything crammed in and buttoned up. Use Igus CF35 VFD cable. 1.5mm2 which is larger than needed but was available.
My question is has anyone taken the spindle apart and fixed the problem properly by adding the missing wire?
Taking apart the connector and bringing the wire external is a big hack. The pin is there for a reason IMHO.
Thanks
Dave