Hi guys
I've been using an Elumatec SBZ122 for a few years now, doing all the programming actually at the machine because none of the office based staff knew how to use Elucad properly.
I've started using Elucad myself now but one problem I'm having is getting the machine to recognise the profiles for the database.
Here is an example of what I'm doing in Elucad, (Elucad LT V1.4)
Click View
Click Profile Database
Highlight Profile
Click Database
Click Export
Select Export PRF
File Name: File Named exactly As In Database
File Type: SBZ 122 v1.06 (*.prf)
The profile perameters are then set (x,y,z, orientation)
The disk is then inserted into the machine.
Select Floppy Disk
Load Data
Highlight File
Press Ok
At this point it reads the file but then when I look in General Perameters it's not there.
It maybe unrelated but as stated the machine is an SBZ122, but when I close down the machine, just before its switched off at the wall, The control panel displays C:\SBZ121
Any help on this would be much appreciated.