[kiwichris]

:-).

Starting to upgrade my Junkbox router a bit so I can cut bits for a better router on it... Cutting out a new X axis bush holder / backlash nut mount (Got some Dumpstercnc nuts ages ago, finally going to mount em)

ncplot told me the cut was going to take just over an hour, so what do you do for an hour? Answer: take lots of short videos with your phone and clip them together. (Don't worry, the video is only actually 3:50..

The bit I was cutting is in the pic below, it's going to replace the dodgy cutting-board backlash nut and bush mounts for the X axis..

The vid: [nomedia="http://www.youtube.com/watch?v=77DXaNVaemI"]YouTube - ‪Cutting a bit for my junk-box CNC router.‬‏[/nomedia]

Enjoy. (or not )