Originally Posted by
big iron
WSS, please let us know how your change over works out.
I have a very large/ old Linde electric eye cutting table that works however we don't use it much, would like to retrofit to cnc. Cand may be the ticket for us as well.
In regards to our Dyna Torch I can see that the Z axcess drive shaft does in fact rock back and forth( small amount) in the up/idle position.
And yes the Z axcess motor will warm up a little more than before???
I have noticed that over time since we installed the new slide assy that we have had to increase our plasma down force.
For a long time we where at 40 now we have it set at 70, our slide assy moves very freely, no drag at all, however If we try to set at 40 now the torch attempts a down move (about 1/2") stops/fires the plasma and sets a fault.
Anyway I am now happy with how the machine works now but we have spent many thousands of dollars up and above the cost of the machine to get there.