Hi
Some of my saved newlydraw files (.ndr) will not open anymore resulting in ND crashing with a send to MS message. Also when engraving using ND text the machine suddenly jolts either left or right about 5-8mm resulting in split engraving.
Anyone experienced these issues? Is it ND? Sometimes it works though...
Regards
Steve
Thread: NewlyDraw problems...
Results 1 to 2 of 2
-
06-23-2011, 01:03 AM #1
Registered
- Join Date
- Jun 2011
- Posts
- 0
NewlyDraw problems...
-
06-23-2011, 05:49 PM #2
Registered
- Join Date
- Dec 2008
- Posts
- 1258
The split text sounds like a mechanical issue, losing steps would be my guess. This could be from running too fast, excess friction or some other factor.
It would be easy to check, after running the job return back to the origin and verify if it is in the same location.
The corrupt .ndr files is not something I have seen before, if you want to send me 1 or 2 I could probably recover them for you.
Zax.
Reply With QuoteSimilar Threads
-
Help with NEWLYDRAW
By J514 in forum Laser Engraving / Cutting Machine General TopicsReplies: 4Last Post: 04-18-2011, 01:37 AM -
Help with NEWLYDRAW
By J514 in forum Laser Engraving / Cutting Machine General TopicsReplies: 8Last Post: 04-17-2011, 03:07 PM -
Help with NEWLYDRAW
By J514 in forum Engraving MachinesReplies: 0Last Post: 04-16-2011, 08:23 AM -
Softlimits in Newlydraw
By sprudelflasche in forum Laser Engraving / Cutting Machine General TopicsReplies: 0Last Post: 05-24-2010, 11:40 AM -
NewlyDRAW - Cut In / Cut Out
By LuAn in forum Laser Engraving / Cutting Machine General TopicsReplies: 2Last Post: 04-06-2009, 06:36 PM
Posting Permissions
