Hi People,

Willing to pay good money for meaningful advise, help, consultation, etc. ...

I need to make a servo drive Mitsubishi MDS C1-V2 to spin a motor to test if that servo works.

My current setup is:
CNC MELDAS C64+sensor screen
Servo drive Mitsubishi MDS C1-V2
Motor HC353BS, or a few other alternatives available.
Power supply MDS CV-260

All this is NOT connected to machine.
If some other components are necessary to make what I need happen I will get them.

Contact: [email protected], (502) 493-1352, or here in the thread or private messages.