[DanOSB]

i have VEXTA Brand Model is PK268-E2.OB

and i tried google and no luck so far...

the info im trying to find.. how much voltage does it require so i can figure out for the power supply issue..

im going to get 2 1200 oz/in motor from ebay or homehobbycnc or something like that

and one 90 oz/in motor for 4 axis setup.. any suggestions for power supply too? (voltage) 24 or 48 or 60 or 80 or something like that

im not experienced in this area.. so im screaming for any help i can get

[ger21]

i have VEXTA Brand Model is PK268-E2.OB

and i tried google and no luck so far...

the info im trying to find.. how much voltage does it require

http://www.orientalmotor.com/product..._B267-B288.PDF

With different size motors, you may need different size power supplies for each one.

[DanOSB]

ok i got those details..

8 lead
187 oz-in holding torque
2 phase
2 amps
4.5 voltage
2.25 resistance
3.6 inductance

now im wondering if i can run 48 volt on that stepper motor? how can i find out what voltage that motor will allow? or i only can run 4.5 voltage.. like i said earlier i know nothing about electronics