[gbeale1970]

Hi, I have just bought a new Syil X2 and was told that the xml file is readily available to communicate with Mach3... I have tried looking everywhere with limited success and had no response from Syil when I contacted them early last week.

In desperation, I tried to create a new XML file using the very poor and badly spelt information within the user document that comes with the mill. This has allowed me to get the X,Y and z comms working to a degree. I am unable to get the spindle to work at all although I can hear a relay clicking???

Has anyone had similar problems and fixed it or even better, does someone have their XML file that works which would save me a heap of trouble!

[Ed from NY]

Did not know Syil made X2's

May be they did or may be it is a kit of sorts?

Did you try some of the SX3 profiles?

[neilw20]

Take some clear photos of all of the circuit boards.
Without that, we don't know what you have.

You say X,Y and Z work to some degree?
Does that mean it is temperature dependent????
Save your XML file. At least that part does something.