Need Help!- need postprocessor for alphacam v7 to weeke (vantage 33 )
homag.
Currently, we use WoodWOP 5.0 for programming. Can anyone help!!! thanks
Need Help!- need postprocessor for alphacam v7 to weeke (vantage 33 )
homag.
Currently, we use WoodWOP 5.0 for programming. Can anyone help!!! thanks
Attached are two Weeke Post Processors, The Homag Post won't be any good without the associated VB Macros as listed after the $3000 line of the Post.
Regards,
Frank.
I tested have some problems found , Part of the success not conversion.
thank you very much all the same