[JaMuTo]

Hi guys, ive finally got the machine working and motors calibrated. Im using Enroute to process my Gcode from Flexisign.
I drew a square 2x2" with sharp corners, but then Mach3 reads the gcode it adds some circle on the top left corner and the sharp edges are replaced by 45dregree angle! Enroute(chair)Mach3. also the X axis cuts 1/16 more than it should be.
Any advice? Thanks once again for any light that can be shared on this issue.

[ger21]

Can you post the g-code? And maybe a screenshot?

[JaMuTo]

i hope this link works


Uploaded with ImageShack.us

G-code:
G90
G0 Z1.
F300
G0 X0.9195Y1.167Z1.
G1 Z-0.
G1 X3.0928
G3 X3.3378Y1.3402 I0. J0.245
G1 Y3.3402
G3 X3.0928Y3.5852 I-0.245 J0.
G1 X1.0928
G3 X0.8478Y3.3402 I0. J-0.245
G1 Y1.3402
G0 Z1.
G0 X0.9195Y1.167Z1.
G0 X0 Y0
G54 L12

Hope that helps, thanks!