Very Similar to my last question... But now im just trying to figure out how to edit my arc centers, so my R's are I's and J's. Thanks Guys
Very Similar to my last question... But now im just trying to figure out how to edit my arc centers, so my R's are I's and J's. Thanks Guys
See post #6 in this thread. Pretty easy.
http://www.cnczone.com/forums/bobcad...ing_issue.html
Mike
Two Haas VF-2's, Haas HA5C, Haas HRT-9, Hardinge CHNC 1, Bother HS-300 Wire EDM, BobCAD V23, BobCAD V28
Thank you... Will this work for v21? I noticed the file extension is different. I.e. V21 uses .cfg, and v23 uses .millpst. Also, doing research, i need a visual basic program to edit my posts for v21. Is this correct?
v 23 post will not work with v21
don't know why there is not any thermwood post's
on bc site
but i found this in the knowledge base for 91000 control
might work ?????
Thermwood 91000.exe
here is a c40
Thermwood C40 91000.exe