Stevo.... the picture is perfect and clears up much... The mechanical configuration is similar to my Mazak eMachines.
Next question is what is the normal axis directions on this machine? On your machine, "up and down" is Y-axis, the table (or the part) is sitting on the B rotary. From I can tell, the machine is a "5-axis HMC" in relation to axis directions correct? So this would make your spindle rotary the A-axis?
From your macro, looks like you program normal to the standard machine axis directions right? (I use 3D Coordinate Rotation a lot so my axes roll around depending on my head angle).
PS: My machine is 'normally' vertical so the axes are like a VMC. My 2 rotary points are the table carries C and the spindle carries B. Up and down with my spindle is Z axis.
It's just a part..... cutter still goes round and round....