[redvanth]

HI all

I am looking to but enroute, just want some clarification,

we are a upholstery company that make light wieght boxes with mdf using 16mm base and 6mm side.

In enroute can i draw one of my shapes and assign a base piee as 16mm and the others as 6mm or do i need to draw the 6mm sides on one job sheet
and the 16mm bits on a seperate job sheet,


thx
anthony

[StuartC]

You could draw them on the same sheet, assign depths of cut, then copy and nest the same thickness pieces on separate sheets.

Stuart