Hi! Looking for help in backing up parameters off a Yasnac 2000 G2 controller. We are using a PC with JobPack communicating through TIP DNC to a DLoG BTR. We are able to upload/download programs with no problems, but we would like to be able to backup the parameters. Whenever we try we get a "Waiting for CNC response" on the TIP communications software. The sequence we use on the controller is 1) set the thumbwheel in the tape reader compartment to 1 (Parameter); 2) set the Mode Switch to EDT and key to 0; 3) press RESET; 4) press PRM; 5) press TAPE OUT. But, nothing happens. Any suggestions? Thanks!