[mousongie]

Hello mates,

Im having a problem with the way edgecam 2010 R1 is outputing the G71 canned cycle for turning. Instead of coming out in two formats...G71 U R and G71 P Q U W F, its coming out into a sigle format G71 U R D........

I tried to check in the post processor editing,but cant find anything.
Can someone help me to correct my mistake.

Thanks in advance!

[meegers]

See the attachment.

This will give you the 2 line G71/G72 canned cycle.

You'll also need to check the format table entries for relevant fields.

[mousongie]

@ meegers. Thank you very much for your help. You are really great. In just few words you gave me a prompt understanding of code constructor. Thank you so ever. Keep your good job up!