[canyon289]

Hi,
I'm practicing Mastercam and right now when I face a workpiece it faces along the X axis of the part. How can I change it to face along the Y axis of the part?

I've tryed using a few of the sort options but none of them have worked so far.

Thanks in advance

[Shane1234]

good question! i also would like to know the answer, as sometimes i use my far right vise in my hurco and the loops on facing sometimes alarms out the overtravel.......
patiently waiting for an answer

[txcncman]

Change Roughing Angle to 90. (Or whatever angle you need.)

[Shane1234]

thanks

[MachiningPartne]

WOW - Thank you - I was looking for the same info.

Change Roughing Angle to 90. (Or whatever angle you need.)