[dfrey2@rocheste]

Running a program where I stop the spindle after first side is finished, flip the part and finish 2nd side. The problem is when the program hits M00, I can't restart the machine without resetting the program and then searching down to where I want to start the 2nd part of the program. Is there a parameter that I can change that will allow me to open the collet without resetting the program?

Thanks in advance
D

[txcncman]

There may be a parameter you can change, but for some reason I am thinking there is an M-code you can use to tell the machine to ignore chuck/collet open/close signal. Look in your manual for such a code.