9207 Tail Stock not in position HiT 18S
My machine is finally at a point where I can run a program. However, nothing works until I put the tail switch in the "CLAMP" position and move the tail spindle until the forward (closest to the chuck) prox switch activates.
I suspect there is some setting that tells the machine that I am doing tail stock work and won't run until the center is against the work.
My documentation shows very little in the operation or programming regarding using the tail stock. My machine has both power tail spindle and power tailstock. The manual only shows the manual tailstock.
Grateful in advance for any guidence. I have the Siemens control.
Regards, Ray
"There is no such thing as a gun free zone."
Ray Brandes, Ray-Vin.Com, PCB, FL 32408 USA