586,069 active members*
3,563 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Mastercam > On Line Training

Thread: On Line Training

Results 1 to 5 of 5
  1. 02-10-2014, 03:59 PM #1
    seijack
    seijack is offline Registered
    Join Date
    Oct 2006
    Posts
    104

    On Line Training

    Hello All,

    I was looking around the site a few weeks ago and I found a good on line training course. Now I can't seem to remember where the site is or where I found it. The classes stood out because they had a course for Active Reports that was about $100. Any Ideas??
    Reply With Quote Reply With Quote
  2. 02-10-2014, 04:10 PM #2
    fizzissist
    fizzissist is offline Gold Member
    Join Date
    Apr 2006
    Posts
    3206
    A mention of what exactly you were looking for training for would be somewhat helpful...
    Reply With Quote Reply With Quote
  3. 02-10-2014, 04:58 PM #3
    Floo
    Floo is offline Registered
    Join Date
    Feb 2008
    Posts
    15
    Hi. Could it have been on udemy or eapprentice?

    Skickat från min GT-I9505G via Tapatalk
    Reply With Quote Reply With Quote
  4. 02-10-2014, 05:54 PM #4
    seijack
    seijack is offline Registered
    Join Date
    Oct 2006
    Posts
    104
    Floo, eapprentice THAT'S IT!! Thanks MUCH!!

    fizzizzist, I did, Active Reports was what I was looking for.
    Reply With Quote Reply With Quote
  5. 02-20-2014, 03:21 PM #5
    cadcam
    cadcam is offline Community Moderator
    Join Date
    Apr 2003
    Posts
    3578
    Ya we did a free seminar last year for an hour on the Active reports now they have made it into a cost course.
    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Cadcam
    Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. KMB1 - Air line / oil line purposes routing.
    By Bob La Londe in forum HURCO
    Replies: 1
    Last Post: 06-25-2012, 01:42 AM
  2. no line number in comment line in mpos
    By MSFAB in forum Surfcam
    Replies: 5
    Last Post: 02-13-2012, 11:51 PM
  3. way to see the g code comands visualized line by line in Bobcad?
    By 777funk in forum BobCad-Cam
    Replies: 3
    Last Post: 04-08-2011, 01:48 AM
  4. Line conditioners for CNC Equipment and poor line conditions
    By WSS in forum Waterjet General Topics
    Replies: 0
    Last Post: 01-14-2011, 03:07 AM
  5. Line Smoothing, point /line no identification
    By dz1 in forum Visual Basic
    Replies: 8
    Last Post: 12-15-2007, 12:03 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules