586,104 active members*
3,371 visitors online*
Register for free
Login

Thread: Mori Seiki SL1 Retrofit

Results 1 to 3 of 3
  1. 10-09-2011, 05:47 PM #1
    thespindoc
    thespindoc is offline Registered
    Join Date
    Sep 2004
    Posts
    51

    Mori Seiki SL1 Retrofit

    I have begun a retrofit on my Mori SL1 lathe that has a bad Yasnac 2000b
    control. I have found all the inputs and outputs to and from the NC except the X and Z limit switches. I know where they are in the right cabinet where the spindle drive is on a terminal strip having come from the limit switches themselves but cannot find them on the NC side despite the electrical schematics saying they are there. Everything else on J6 connnector is present
    as per schematics but these 4 limit switches. Any ideas?

    Thanks
    Keith
    Reply With Quote Reply With Quote
  2. 10-12-2011, 03:38 PM #2
    JHCHOPPERS
    JHCHOPPERS is offline Registered
    Join Date
    May 2007
    Posts
    100
    Can't wait to see your progress on this. Post some pics when you can...

    My SL1 project has been stalled out again.

    Thanks,
    JH
    Reply With Quote Reply With Quote
  3. 10-23-2011, 07:08 AM #3
    ROBBY 68
    ROBBY 68 is offline Registered
    Join Date
    Jul 2009
    Posts
    80
    Hi thespindoc
    I have an SL2, and the only I/O is on left side of Main Power supply
    just behind tape reader, don´t know if this applies to you SL1?
    you may find them there.
    Do you have elctrical schematic electronic?
    Robby
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Mori Seiki TL2 Retrofit
    By maxman in forum Uncategorised MetalWorking Machines
    Replies: 0
    Last Post: 07-27-2011, 12:05 PM
  2. Did Mori Seiki Buy Hitachi Seiki?
    By Billet Sean in forum Mori Seiki lathes
    Replies: 6
    Last Post: 05-05-2011, 04:12 AM
  3. MORI SL-1 RETROFIT.
    By GPena in forum Mori Seiki lathes
    Replies: 2
    Last Post: 05-20-2010, 06:54 PM
  4. Retrofit MORI-SEIKI SL1-A
    By clintan99 in forum Servo Motors / Drives
    Replies: 2
    Last Post: 12-11-2009, 10:56 PM
  5. Help Required - Mori Seiki TL 2 (RETROFIT)
    By maxman in forum Uncategorised MetalWorking Machines
    Replies: 6
    Last Post: 04-08-2007, 03:22 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules