Our operators program in Mazatrol on our mill and lathe. Does MasterCam output native mazatrol or would we have to go back to G-code if we went with MasterCam?
Our operators program in Mazatrol on our mill and lathe. Does MasterCam output native mazatrol or would we have to go back to G-code if we went with MasterCam?
There is a post available that will write native Mazatrol. It's not 100% from what I've seen, but it works. I think there's a 30 day trial at their site.
http://www.camaix.com/
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Hello,
My advice.....If you want to use mastercam, which is a excellent program, get the g-code translator package for your mazak's. Then everything will work 100%
My 2 cents
Dalen Mealer