Have a sign warehouse jaguar II that's been sitting for a few months. Now it only shows jaguar II v1.1 on the screen then goes to some boot thing and just hangs there. I'm guessing it needs a firmware load. Anyone done this?
Have a sign warehouse jaguar II that's been sitting for a few months. Now it only shows jaguar II v1.1 on the screen then goes to some boot thing and just hangs there. I'm guessing it needs a firmware load. Anyone done this?
Hello
Here is litografa.lt/index.php?downloads firmware upgrader. Download it and firmware, install firmware upgrader on your PC.
Switch on plotter in upgrade mode and write new firmware.
Thank you, I will try that tonight.
Well, I might have bricked this thing now. All it does is boot to the jaguar II V1.1 screen and goes no further. Can't hold down the button to get in to serial screen any longer.
In this case problem is in mother board. Try to check all connections on MB, in worst case ask price of new motherboard from Signwarehouse :drowning: