Selective Soldering Robot Conversion to Mach3
Hi All,
I've finally stated my conversion of my Selective Soldering Machine over to Mach3.
The goal of this exercise is to end up with a machine that is a lot easier to program as the machine currently requires the programming to be done via 2 separate Jog pendants.
The link below shows the machine operating with the original software.
Selective soldering through hole components - YouTube
The write up of the conversion can be found at;
Selective Soldering Robot Conversion to Mach3
Cheers,
Peter.
-------------------------------------------------
Homann Designs - http://www.homanndesigns.com/store