Originally Posted by
SpruTormaCam
I've got a SprutCam question that I have been wasting way way too much time on.
I would like to use fixture offsets other than G54 - G59, for example G59 P10. I'm using my Tormach 1100 as a VLathe and have multiple turning tools set up gang style and want to use the extended coordinate system for this project.
I haven't figured out how to do that with SC7 other than going back and editing the post.
I wouldn't think SC7 would just support 6 offsets so I'm assuming there is an easy step I'm missing.
Thanks, Mark...
Tormach 1100 sII w/ATC
SC7 1.5 rev 45534