Could someone show me an example of a g86 boring cycle that uses an m19 to orientate the spindle pull away from the wall then rapid out?
Thread: G86 with an m19
Results 1 to 2 of 2
-
11-02-2011, 12:41 PM #1
Registered
- Join Date
- Oct 2011
- Posts
- 0
G86 with an m19
-
03-02-2012, 04:02 AM #2
Registered
- Join Date
- Mar 2012
- Posts
- 27
If your post is not setup for it then you have to edit the post to make it output correctly. Otherwise just go to MDI and punch in M19 spindle orient and see where it stops. If it stops in the 12 o'clock position then just add a Y-.02 move before it pulls out. Or IF (NEXTCLFILE(?)=?expression) Y* ENDIF. But since Esprit is not in front of me I can't tell you the CLFILE & Expression for the logic. Id just use the latter.
Reply With Quote
