Seeking assistance with a Bridge Port Series 2 Milling Machine. It is equipped with a Heidenhain TNC 155 B/TNC 155 Q controller. Bought at auction, back up batteries dead, lost program. Need assistance with reprograming.
Seeking assistance with a Bridge Port Series 2 Milling Machine. It is equipped with a Heidenhain TNC 155 B/TNC 155 Q controller. Bought at auction, back up batteries dead, lost program. Need assistance with reprograming.
The PLC is on PROMS. You need the parameters. Search the posts.
note that some parameters are generic and some are machine specific (backlash, distance allowed to travel from home switch).
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
The PLC is on PROMS. You need the parameters. Search the posts.
note that some parameters are generic and some are machine specific (backlash, distance allowed to travel from home switch).
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I bumped the parameter lists but there is not your machine there
You need to get a manual, any Bridgeport/heidenhain knee mill manual will get you close, but the series 2 has several differences