[RMARCH]

Hi , I was wondering if anyone has the machine parameters for a 1988 Bridgeport Interact 412V Heidehnain TNC151 P control . I recently bought the machine and it had problems when i got it. ( I knew this ) I was just looking at the parameter list i got with the machine and it is for the TNC 155 control.
I'm not sure if they are the same or not.


Thanks

[gus]

i 'think' the parameters for the 155 are extended, for graphics etc, but that the baseline parameters are valid. Look at a manual for the 151 and 155 and confirm that this is the case

[RMARCH]

HI Gus , Thanks for the Reply !!!! I think it's strange that the parameter list i got with the machine is not a match to the control. I don't think bridgeport would do this.....then again you never know......? I was hoping to find a list for the TNC151 so i could compare them.

[jmccracken]

Hi ... I've just purchased an 1988 Interact with the Heidenhain TNC 151. Attached are the factory machine parameters.