[rbocaz]

I have my DIY plasma cutting system. I've been cutting for more than a year, but I always find the problem when the sheet metal is wrapped. So I decided to upgrade to a THC system. My problem is I don't know for sure which THC to use, so I can keep using the existing BOB PMDX-122.

Any advice, experience is welcome.

Rick

[claudiu]

I`m in the same situation.
You can choose from Cand, Proma and Agelkom.
Another MM`er is mounting an Agelcom device, I chose Proma, so we can compare future experiences. Proma seems to me a very simple system to control your height setting up the desired voltage parameter. We will see!?
Cand sells only two Set`s, so it up to you.

[rbocaz]

I`m in the same situation.
You can choose from Cand, Proma and Agelkom.
Another MM`er is mounting an Agelcom device, I chose Proma, so we can compare future experiences. Proma seems to me a very simple system to control your height setting up the desired voltage parameter. We will see!?
Cand sells only two Set`s, so it up to you.

I chose candcnc but my plasma machine doesn't work very much with the candcnc hardware.

[stirling]

if you use a powermax cutter this may be another option to those already mentioned.

[asuratman]

wow so expensive! is that stand alone?

[asuratman]

Maybe you should contact Torchead candcnc and ask what to do.

[stirling]

wow so expensive!

Huh???? how do you figure that out?

[asuratman]

I did not know exchange rate, then I found it cheap after I read forex. Sorry.

[stirling]

I did not know exchange rate, then I found it cheap after I read forex. Sorry.

shame you didn't checkout exchange rates BEFORE you dissed it. It's hard enough making a living these days as it is.....(nuts)