[handy223]

Hello all,

We have a 1990 Makino that suffers from memory loss after the operator wiped it clean.
I have some of the original parameters, BUT not the diagnostic parameters.

When you call up a tool change (M6) the machine successfully completes the exchange but always brings up a 099 P/S alarm at the end of the O9001 program (tool change program).

I've been on the phone with Makino and Fanuc for 2 days and still no resolve.

ANY ideas ....Suggestions......HELP ?

[muhammad@arif]

hi
how r u Mr.handy my machine center makino FNC60 parameter lost plz help for this parameter for thin E-mail([email protected])

[bilalyunus]

would it be possible for you to email me the parameters of the machine so i could try to get my machine running again, i lost all the parameters due to an electricity issue while changing the battery.

We have installed a machine Lablonde makino with a fanuc system of B-61395-E /01 .

We have the problem of basic paremetres removed.



Below are the machine details



LMA Machine Serial No: V 2149
LM Machine Serial No: -
Type: FNC 60 – A20 (BT)
V9020E-01

thank you for your help

[jjautomation]

Hello all,

We have a 1990 Makino that suffers from memory loss after the operator wiped it clean.
I have some of the original parameters, BUT not the diagnostic parameters.

When you call up a tool change (M6) the machine successfully completes the exchange but always brings up a 099 P/S alarm at the end of the O9001 program (tool change program).

I've been on the phone with Makino and Fanuc for 2 days and still no resolve.

ANY ideas ....Suggestions......HELP ?

Hi
Did you get any solution for the above problem.
I am also facing same problem. PS 099 pops up as soon as M6 is about to finsh.
Rgds
Harmeet Singh

[GURMEET85]

Hi
Did you get any solution for the above problem.
I am also facing same problem. PS 099 pops up as soon as M6 is about to finsh.
Rgds
Harmeet Singh

Same problem here.

[GURMEET85]

Hello all,

We have a 1990 Makino that suffers from memory loss after the operator wiped it clean.
I have some of the original parameters, BUT not the diagnostic parameters.

When you call up a tool change (M6) the machine successfully completes the exchange but always brings up a 099 P/S alarm at the end of the O9001 program (tool change program).

I've been on the phone with Makino and Fanuc for 2 days and still no resolve.

ANY ideas ....Suggestions......HELP ?

Same problem here