Got hit by lighting a year ago last September. Had to replace shop computer and the chip in my 1st generation controller. Got the machine to jog with the Deskcnc software but never ran any code. A couple days ago I generated some code from a dxf file and found the m3 & M reversed....same with spindle button on the control panel. Click off turns spindle on ....click on turns spindle off..

I am using a USB to serial cable that was also replaced. Could this be swapping them codes?????

I ran several codes today and everything seems to work fine except for the reversed m's

Hope someone can offer a solution. I am running V 2.0.1.93---------

Also would like to know if the latest version 2.0.2.65 will work with my old controller.


Gary