more like a link to no where :-(
tried the obvious repair but that did not work either.
Jon
Sliding down the razor blade of life.
i don't know why it doesn't work... link is bad?
goto youtube search Ihcnc running 3600rpm Mach3 madcam
Try this one.
[ame=http://www.youtube.com/watch?v=zJkHFhyR6x8]Ihcnc running 3600rpm Mach3 madcam - YouTube[/ame]
Congratulations on the new mill, you should hqave alot of fun making stuff for the bikes. BTW nice results on the CRF @ 45+ hp.
Ron