Hi,
New to the forums and hope someone might be able to help me. I have a
Vicon 8000 Fabricator Model 2000 give or take a year.
Running version 2.20 of the Vicon cutting software which uses a double seek process when seeking home.
It seems to find the x-axis correctly but upon seeking the y-axis it comes in fast once, backs out fast, then returns slow (which should be normal) but upon going to home it travels very slowly across the table along the y-axis and requires an e-stop or controller flush to stop it's movement. If stopped with the e-stop a window pops up giving 3 choice on whether to resume cut, flush controller, etc. If I choose to resume cut it will move to the correct x-axis position and it will move 2 3/4 inches in the positive direction on the y- axis from where it stopped with the e-stop and stop. It now thinks this position is home and will over travel engaging the over travel limit switches.
Any help is greatly appreciated.
Thanks,
Kent