Anyone have or know of a post processor for Pro/Engineer (Pro/NC)? If not which one of the included ones can I use?
Anyone have or know of a post processor for Pro/Engineer (Pro/NC)? If not which one of the included ones can I use?
you have to know what type of controller that you are using...say if u r using Fanuc, there's several type of fanuc (OM, 16i, 18i, 21i, etc) and once u provided that, ppl can help you out what type of pp is the most suitable one.
Ummm... Mach3? Since this is the Mach software forum...Originally Posted by TeQ
mgamber,
Did you have any luck getting a Pro/E to Mach postprocessor? If so, could you please share it? I am looking for it too.
Thanks,
Mark