I have a rong fu 31 mill that I am restoring it was a previous retrofit from the late 90's. The controller was to old and not working. I stripped the electronics and have all new hardware ready to go. I purchased a cabinet, power supply, leadshine drivers, and cnc4pc breakout board from kelling to start. I also have a new computer with Mach 3 ready to go.

I can get this going on my own but it will take me a little longer then I would like. I know many people have put these together on there own already and are ahead of the curve so to speak.

If you are local to Southern California and already have experience wiring from scratch cnc controls as mentioned to work with Mach 3, I would like your help.

If you are interested in helping I would be elated. Please email me or send me a message. I can buy lots of beer or soda and a steak dinner if you are interested in helping =-).

Eric