I would like to know how to properly draw the attached file. I would like to know how to get a fillet between the red "floor" & blue "wall" (.250"). Thanks for any help here. The file is a compressed .BBCD. Using V24.
VPL
I would like to know how to properly draw the attached file. I would like to know how to get a fillet between the red "floor" & blue "wall" (.250"). Thanks for any help here. The file is a compressed .BBCD. Using V24.
VPL
Select "Solid boolean add" and then select the 2 solids and hit the spacebar for "OK". The run the fillet command and select the floor as the geometry and select ok.
I have attached a modified drawing that will allow filleting of the surface. Make sure that you select the lines to the surface and not the top of the surface. There seems to have been an inconsistency to the surface that was causing it to error. What I did was resurfaced the model to eliminate any inconsistencies in the solid. Enjoy