Hello,
Im trying to setup a breakout board with mach3.
I have a breakout board and a stepper driver for higher voltages.
The driver is an l298 and has input ENA IN1 IN2 IN3 IN4 ENB,
output motor A(1,2) and motor B(1,2).
When ENA and IN1 or IN2 is high the output A is VMS, same with ENB.
I have setup a dir and step in mach and tried to wire them to driver inputs but motor only locks up or buzzes.
This is my first breakout wiring, the motor is a 4 wire.