586,033 active members*
3,099 visitors online*
Register for free
Login

Thread: Drive letters for Sodick A325

Results 1 to 4 of 4
  1. 01-26-2012, 02:25 PM #1
    rstiverson
    rstiverson is offline Registered
    Join Date
    Nov 2011
    Posts
    0

    Drive letters for Sodick A325

    Is there any way to change the hard disk and floppy disk drive letters on a Sodick A325/Mark 25?

    I bought a usb drive to replace the floppy, but from what I can tell it needs to be assigned drive letter B. Right now my hard disk is B and my floppy is C.

    Thanks,

    Randy
    Reply With Quote Reply With Quote
  2. 02-02-2012, 01:59 PM #2
    rstiverson
    rstiverson is offline Registered
    Join Date
    Nov 2011
    Posts
    0
    Does anybody know if this can even be done?
    Reply With Quote Reply With Quote
  3. 02-08-2012, 02:57 PM #3
    rstiverson
    rstiverson is offline Registered
    Join Date
    Nov 2011
    Posts
    0
    ???????
    Any help would be appreciated
    Reply With Quote Reply With Quote
  4. 02-13-2012, 05:06 PM #4
    sodickappsguy
    sodickappsguy is offline Registered
    Join Date
    Dec 2006
    Posts
    131
    i am not sure it can be done. Normally the B drive is reserved for a second floppy drive. I dont think you can change much in the software on a mark 25.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Sodick (Panasonic) servo drive
    By emexcee380 in forum EDM Discussion General Topics
    Replies: 5
    Last Post: 07-02-2012, 09:30 PM
  2. Sodick A325 burning very slow
    By rstiverson in forum EDM Discussion General Topics
    Replies: 5
    Last Post: 12-15-2011, 03:12 AM
  3. Problems with Sodick A325 AWT
    By rstiverson in forum EDM Discussion General Topics
    Replies: 2
    Last Post: 11-10-2011, 07:00 PM
  4. Sodick A325 abnormal computer error
    By Missouri wire in forum EDM Discussion General Topics
    Replies: 24
    Last Post: 11-10-2011, 03:14 AM
  5. dxf letters help
    By soundoffaudio in forum MetalWork Discussion
    Replies: 3
    Last Post: 01-12-2011, 06:07 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules