help
what is ISO 40 tool holders for angle of the cone?
can not find it anywhere!
kujau
help
what is ISO 40 tool holders for angle of the cone?
can not find it anywhere!
kujau
What exactly is your need? The link below has some info on the ISO40 Taper.
http://www.schaublin.ch/catalogues/PO053-060.pdf
I'm doing is building a spider. so that's why I need to know the angle.
what does 8 17:50 means?
8 degrees 17 minutes 50 seconds is the side angle.
aren;t they all 7 in 24 taper?
In the words of the Toolman--If you didn't make it yourself, it's not really yours!
Remember- done beats perfect every time!!
arn't they all 7 in 24 taper?
In the words of the Toolman--If you didn't make it yourself, it's not really yours!
Remember- done beats perfect every time!!