mach3 problem!! When i live a cnc mill to work a relief it does't do it right but it goes diagonally, i mean it deform the picture so that it is not squared but rhombus like, and also if i tell him to make 30x20 it makes it 33x20 or something like this what am i doing wrong?
before reinstalling mach3 everything was just fine i did Axisi Calibration
Working on 3 axis mashine
Here is a pic. on example
http://img855.imageshack.us/img855/5276/examplex.jpg
Thread: Mach3 problem,help!
Results 1 to 2 of 2
-
02-01-2012, 09:49 AM #1
Registered
- Join Date
- Nov 2011
- Posts
- 0
Mach3 problem,help!
-
02-02-2012, 11:40 PM #2
Registered
- Join Date
- Jul 2007
- Posts
- 148
Greetings to our friends in Croatia. All of the Mach3 experts hang out in this section of the Zone, Mach Software (ArtSoft software) - CNCzone.com-The Largest Machinist Community on the net! . I'm sure you'll get a faster reply if you post your question there. Good luck.
Reply With QuoteSimilar Threads
-
Mach3 problem with new cnc
By jimmyaz in forum DIY CNC Router Table MachinesReplies: 9Last Post: 06-04-2011, 12:38 PM -
MACH3 -> LPT Problem! Help.
By spotlite in forum Mach MillReplies: 3Last Post: 08-07-2008, 01:37 AM -
mach3 problem
By cicio in forum Australia, New Zealand Club HouseReplies: 3Last Post: 02-21-2008, 09:54 AM -
problem with Mach3
By jed102 in forum Mach Software (ArtSoft software)Replies: 5Last Post: 01-27-2008, 11:38 PM -
Problem with Mach3
By SCOTTY76SA in forum SheetCamReplies: 3Last Post: 05-27-2007, 02:34 PM
Posting Permissions
