[jerrywi]

Hello Group and Bob,

I've been working on my build for some time now.

I've completed the wood portion and have been working on the aluminum parts.

I've been following the forum and have notice some dimension errors mentioned and have taken note of them.

I am currently working on part number #19, page 52. The material list is .1875 x 2.5 inches, The layout dimension is 2.25 inches. Am I to trim down the 2.5 inch side to 2.25 inches? Or could this be an over site?

Thanks for your support
jerrywi

[cgodwin]

2.5" is just the dimension of the raw stock - not the finished part. The 2.25" size is correct for the part. You must trim it down from 2.5 to avoid interfering with the Z axis.

[jerrywi]

Cgodwin

Thanks a lot for the quick response, I wasn't sure. also thanks for the heads up on the interference with the Z axis.

Jerrywi