Hi
As the title suggests I have a Hawk 5M on which the error message Power Cabinet Overtemp is now highlighted on the screen.(see pic) I have investigated the cabinet and it does not seem to be overheating but I have noticed that the yellow LED on the the Canbus card is always on ( along with the red watchdog LED). I can't see any external sensor in the cabinet but there might be.
Is it normal for this Overtemp LED to be permanently on?
Regards
George
Thread: Hawk 5M Power Cabinet OverTemp
Results 1 to 2 of 2
-
02-02-2012, 04:06 PM #1
Registered
- Join Date
- Mar 2010
- Posts
- 0
Hawk 5M Power Cabinet OverTemp
-
02-13-2012, 04:21 PM #2
Registered
- Join Date
- Mar 2010
- Posts
- 0
I' ll answer this one myself :-)
The two LEDs should not be on.
In a previous Hurco thread for a different mill it was suggested to clean the ISA edge connectors and guess what , it worked!
George
Reply With QuoteSimilar Threads
-
Hawk 5
By IC4111 in forum HURCOReplies: 1Last Post: 04-24-2013, 04:16 AM -
AB ultra 100 series with indexing-motor ocilating and overtemp
By jrick in forum Servo Motors / DrivesReplies: 0Last Post: 08-26-2010, 05:11 AM -
DOA...Hawk 5
By ChipKing in forum HURCOReplies: 7Last Post: 03-03-2010, 04:03 AM -
control cabinet overtemp
By judleroy in forum HURCOReplies: 3Last Post: 08-13-2008, 08:46 PM -
Identifying usable components in a BP BOSS3 Power Cabinet
By damae in forum Bridgeport / Hardinge MillsReplies: 5Last Post: 04-03-2006, 06:25 PM
Posting Permissions
