[jflachs34]

I have a Camtech L20 laser engraver. Im running 2- Teknic SST-1500-RCX drives with 2 Teknic M3482-FT servos. Im having trouble getting anything online in the quickset software. I have the comm cable connected to the right port and the com port in quickset is set right. Do I need to use a Oscope in order to use quickset? Thanks

[janbbeck]

I have a Camtech L20 laser engraver. Im running 2- Teknic SST-1500-RCX drives with 2 Teknic M3482-FT servos. Im having trouble getting anything online in the quickset software. I have the comm cable connected to the right port and the com port in quickset is set right. Do I need to use a Oscope in order to use quickset? Thanks

I can connect to the sst1500 without connecting the scope, if that is what you mean. I my case, however, I cannot get into the menu that sets the custom motor. The documentation says to press ctrl-shift-M, but quickset does not react to that at all...

Does anybody here have experience with this software/hardware and is willing to lend a helping hand?